Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 524 (Engine Control System - Sedan) >> DTC P0340, P0345: CMP Sensor (Phase) >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2005 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Crank engine for at least 2 seconds and run it for at least 5 seconds at idle speed.
  4. If 1st trip DTC is detected, go to "Diagnostic Procedure "

    If 1st trip DTC is not detected, go to next step.

  5. Maintaining engine speed at more than 800 RPM for at least 5 seconds.
  6. If 1st trip DTC is detected, go to "Diagnostic Procedure "
    Fig 1: Locating Data Monitor Display Screen
    G02348553Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals