6. Check For EVAP Leak

WARNING: This page is about a different car, the 2004 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

With CONSULT-II

Turn ignition switch ON.
Select "EVAP SYSTEM CLOSE" of "WORK SUPPORT" mode with CONSULT-II.
Touch "START" and apply pressure into the EVAP line until the pressure indicator reaches the middle of the bar graph.
NOTE:
- Never use compressed air or a high pressure pump.
- Do not exceed 4.12 kPa (0.042 kg/cm² , 0.6 psi) of pressure in the system.
Using EVAP leak detector, locate the EVAP leak. See Figure. For the leak detector, refer to the instruction manual for more details.
Refer to "EVAPORATIVE EMISSION LINE DRAWING ".

Fig 1: CONSULT-II Display Screen

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 8 .

NG: Repair or replace.