6. Check For EVAP Leak

WARNING: This page is about a different car, the 2004 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

With CONSULT-II

Turn ignition switch ON.
Select "EVAP SYSTEM CLOSE" of "WORK SUPPORT" mode with CONSULT-II.
Touch "START" and apply pressure into the EVAP line until the pressure indicator reaches the middle of the bar graph.
NOTE:
- Never use compressed air or a high pressure pump.
- Do not exceed 4.12 kPa (0.042 kg/cm² , 0.6 psi) of pressure in the system.
Fig 1: CONSULT-II Display Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Using EVAP leak detector, locate the EVAP leak. For the leak detector, refer to the instruction manual for more details.

Fig 2: Checking For EVAP Leak
Courtesy of NISSAN MOTOR CO., U.S.A.

Refer to "EVAPORATIVE EMISSION LINE DRAWING ".

OK or NG

OK: GO TO 8.

NG: Repair or replace.