Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 367 (2004 - Engine Control System - Coupe) >> ASCD Brake Switch >> Diagnostic Procedure >> M/T Models >> 4. Check ASCD Brake Switch Power Supply Circuit

4. Check ASCD Brake Switch Power Supply Circuit

WARNING: This page is about a different car, the 2004 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF.
  2. Disconnect ASCD brake switch harness connector. See Figure.
  3. Turn ignition switch ON.
  4. Check voltage between ASCD brake switch terminal 1 and ground with CONSULT-II or tester.
    1. Voltage: Battery voltage 

OK or NG 

OK: GO TO 6 .

NG: GO TO 5.

Fig 1: Checking Power Supply Circuit
G00720492Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals