Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1976 (Engine Control System - VK45DE) >> DTC P0011, P0021: IVT Control >> DTC Confirmation Procedure >> Procedure For Malfunction A >> With CONSULT-II

With CONSULT-II

WARNING: This page is about a different car, the 2005 Infiniti FX45. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Maintain the following conditions for at least 10 consecutive seconds.
    ENGINE SPEED

    ENG SPEED More than 2,000 rpm (A constant rotation is maintained.)
    COOLAN TEMP/S More than 70°C (158°F)
    Selector lever 1st or 2nd position
    Driving location uphill Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)
    Fig 1: Identifying Consult-II Data Monitor
    G02361413Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Maintain the following conditions for at least 20 consecutive seconds.
    ENGINE SPEED

    ENG SPEED Idle
    COOLAN TEMP/S More than 70°C (158°F)
    Selector lever P or N position
  5. If the 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE  ".
scientia non olet · About Mike's Workshop Manuals