Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1734 (Body, Lock & Security System (Coupe)) >> Intelligent Key System >> Check "KEY" Warning Lamp (RED)

Check "KEY" Warning Lamp (RED)

WARNING: This page is about a different car, the 2006 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK WARNING LAMP OPERATION 

    With CONSULT-II 

    • Check "INDICATOR" in "ACTIVE TEST" mode with CONSULT-II.
    • Select "RED ON".

    "KEY" warning lamp (red) should illuminate.

    Fig 1: Display CONSULT-II - Active Test
    G04182031Courtesy of NISSAN MOTOR CO., U.S.A.

    Without CONSULT-II 

    Check voltage between Intelligent Key unit harness connector M75 terminal 9 and ground.

    TERMINALS VOLTAGE REFERENCE

    Connector Terminal (Wire cooler) Condition Voltage (V) (Approx.)
    (+) (-)
    M75 9 (R/G) Ground When Intelligent Key is outside vehicle, press ignition switch. 0
    Ignition switch OFF Battery voltage

    OK or NG 

    OK: INSPECTION END

    NG: GO TO 2.

    Fig 2: Identifying Voltage Between Intelligent Key Unit Connector M75 Terminal 9 And Ground
    G04182032Courtesy of NISSAN MOTOR CO., U.S.A.
  2. CHECK COMBINATION METER CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect Intelligent Key unit connector and combination meter connector.
    3. Check continuity Intelligent Key unit harness connector M75 terminal 9 and combination meter harness connector M20 terminal 50.

      9 (R/G) - 50 (R/G): Continuity should exist  .

    4. Check continuity Intelligent Key unit harness connector M75 terminal 9 and ground.

      9 (R/G) - Ground: Continuity should not exist  .

      Fig 3: Identifying Continuity Intelligent Key Unit Connector M75 Terminal 9 And Ground
      G04182033Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: GO TO 3.

    NG: Repair or replace harness between Intelligent Key unit and combination meter.

  3. CHECK INTELLIGENT KEY UNIT INPUT SIGNAL 
    1. Connect combination meter connector.
    2. Check voltage between Intelligent Key unit harness connector M75 terminal 9 and ground.

      9 (R/G) - Ground: Battery voltage 

    OK or NG 

    OK: Check condition of harness and connector.

    NG: Check combination meter. Refer to "COMBINATION METERS ".

    Fig 4: Identifying Voltage Between Intelligent Key Unit Connector M75 Terminal 9 And Ground
    G04182034Courtesy of NISSAN MOTOR CO., U.S.A.