Power Supply Circuit Inspection
WARNING: This page is about a different car, the 2006 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FUSES
Check that the following fuses are not blown.
FUSES REFERENCE CHARTUnit Terminals Signal name Fuse No. DVD player 16 Battery power 29 15 Ignition switch ACC or ON 4 OK or NG
OK: GO TO 2.
NG: If fuse is blown, be sure to eliminate cause of problem before installing new fuse. Refer to "POWER SUPPLY ROUTING CIRCUIT "
- POWER SUPPLY CIRCUIT CHECK
- Disconnect DVD player connector M205.
- Check voltage between the DVD player and ground.
CONNECTOR TERMINAL GROUND VOLTAGE SPECIFICATIONSUnit Terminal No. OFF ACC ON (+) (-) Connector Terminal DVD player M205 16 Ground Battery voltage Battery voltage Battery voltage 15 Ground 0V Battery voltage Battery voltage OK or NG
OK: GO TO 3.
NG :
- Check connector housings for disconnected or loose terminals.
- Repair harness or connector.
- GROUND CIRCUIT CHECK
Check continuity between DVD player harness connector M206 terminal 22 and ground.
Continuity should exist.
OK or NG
OK: Inspection End.
NG :
- Check connector housings for disconnected or loose terminals.
- Repair harness or connector.