Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1721 (Audio, Visual, Navigation & Telephone System) >> Audio >> Power Supply Circuit Inspection

Power Supply Circuit Inspection

WARNING: This page is about a different car, the 2006 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FUSES 

    Check that the following fuses are not blown.

    FUSES REFERENCE CHART

    Unit Terminals Signal name Fuse No.
    Audio unit 6 Battery power 29
    10 Ignition switch ACC or ON 4
    AV switch 1 Battery power 29
    2 Ignition switch ACC or ON 4
    BOSE speaker amp. (with BOSE) 1 Battery power 29
    Display control unit 12 Ignition switch ON or START 12
    Subwoofer (BOSE system) 6 Battery power 17

    OK or NG 

    OK: GO TO 2.

    NG: If fuse is blown, be sure to eliminate cause of problem before installing new fuse. Refer to "POWER SUPPLY ROUTING CIRCUIT "

  2. POWER SUPPLY CIRCUIT CHECK 
    1. Disconnect audio unit connector M43, subwoofer connector B72 (with BOSE) and BOSE speaker amp. connector B74 (with BOSE).
    2. Check voltage between the audio unit and ground.
      CONNECTOR TERMINAL GROUND VOLTAGE SPECIFICATIONS

      Unit Terminal No. OFF ACC ON
      (+) (-)
      Connector Terminal
      Audio unit M43 6 Ground Battery voltage Battery voltage Battery voltage
      10 Ground 0V Battery voltage Battery voltage
      Fig 1: Checking Voltage Between Audio Unit And Ground
      G04177644Courtesy of NISSAN MOTOR CO., U.S.A.
    3. Check voltage between subwoofer (BOSE system) and ground.
      CONNECTOR TERMINAL GROUND VOLTAGE SPECIFICATIONS

      Unit Terminal No. OFF ACC ON
      (+) (-)
      Connector Terminal
      Subwoofer B72 6 Ground Battery voltage Battery voltage Battery voltage
      Fig 2: Checking Voltage Between Subwoofer (BOSE System) And Ground
      G04177645Courtesy of NISSAN MOTOR CO., U.S.A.
    4. Check voltage between BOSE speaker amp. (with BOSE) and ground.
    CONNECTOR TERMINAL GROUND VOLTAGE SPECIFICATIONS

    Unit Terminal No. OFF ACC ON
    (+) (-)
    Connector Terminal
    BOSE speaker amp. B74 1 Ground Battery voltage Battery voltage Battery voltage

    OK or NG 

    OK: GO TO 3.

    NG :

    • Check connector housings for disconnected or loose terminals.
    • Repair harness or connector.
    Fig 3: Checking Voltage Between Bose Speaker Amp.(With BOSE) And Ground
    G04177646Courtesy of NISSAN MOTOR CO., U.S.A.
  3. GROUND CIRCUIT CHECK 

    Check continuity between subwoofer (BOSE system) harness connector B72 terminal 5 and BOSE speaker amp. (with BOSE) harness connector B74 terminal 17 and ground.

    Continuity should exist. 

    OK or NG 

    OK: Inspection End.

    NG :

    • Check connector housings for disconnected or loose terminals.
    • Repair harness or connector.
    Fig 4: Checking Continuity Between Connector Terminal 5 And Connector Terminal 17 And Ground
    G04177647Courtesy of NISSAN MOTOR CO., U.S.A.