Passenger Seat Control Unit Ignition Signal Circuit Check

WARNING: This page is about a different car, the 2005 Nissan 350Z. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FUSE
- Check 10A fuse [No. 9, located in the fuse block (J/B)].
- Check 10A fuse [No. 12, located in the fuse block (J/B)].
NOTE: Refer to "COMPONENT PARTS AND HARNESS CONNECTOR LOCATION ".

OK or NG
- OK : GO TO 2.
- NG : If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse. Refer to "POWER SUPPLY ROUTING CIRCUIT ".
CHECK PASSENGER SEAT CONTROL UNIT POWER SUPPLY
Check voltage between passenger seat control unit and ground.

Fig 1: Connector Terminal And Voltage Reference Table
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Checking Voltage Between Passenger Seat Control Unit And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG
- OK : Replace passenger seat control unit.
- NG : Repair or replace the harness between passenger seat control unit and fuse block (J/B).