ECM Inspection Table

WARNING: This page is about a different car, the 2005 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

Specification data are reference values and are measured between each terminal and ground. Pulse signal is measured by CONSULT-II.

CAUTION: Do not use ECM ground terminals when measuring input/output voltage. Doing so may result in damage to the ECMs transistor. Use a ground other than ECM terminals, such as the ground.

Fig 1: ECM Inspection Table (1 Of 9)

G02360236

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: ECM Inspection Table (2 Of 9)

G02360237

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 3: ECM Inspection Table (3 Of 9)

G02360238

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 4: ECM Inspection Table (4 Of 9)

G02360239

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 5: ECM Inspection Table (5 Of 9)

G02360240

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 6: ECM Inspection Table (6 Of 9)

G02360241

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 7: ECM Inspection Table (7 Of 9)

G02360242

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 8: ECM Inspection Table (8 Of 9)

G02360243

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 9: ECM Inspection Table (9 Of 9)

G02360244

Courtesy of NISSAN MOTOR CO., U.S.A.

*: Average voltage for pulse signal (Actual pulse signal can be confirmed by oscilloscope.)