Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1415 (Engine Control System - VQ35DE) >> DTC P1805: Brake Switch >> Component Inspection >> Stop Lamp Switch

Stop Lamp Switch

WARNING: This page is about a different car, the 2005 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect stop lamp switch harness connector.
    Fig 1: Disconnecting Stop Lamp Switch Harness Connector
    G02361052Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Check continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    CONTINUITY BETWEEN TERMINALS CHART

    Conditions Continuity
    Brake pedal: Fully released Should not exist.
    Brake pedal: Slightly depressed Should exist.
    Fig 2: Checking Continuity Between Stop Lamp Switch Terminals 1 And 2
    G02361053Courtesy of NISSAN MOTOR CO., U.S.A.
  3. If NG, adjust stop lamp switch installation, Refer to "BRAKE PEDAL ", and perform step 2 again.
scientia non olet · About Mike's Workshop Manuals