Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1415 (Engine Control System - VQ35DE) >> DTC P1572: ASCD Brake Switch >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2005 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Press MAIN switch and make sure that CRUISE indicator lights up.
  4. Drive the vehicle for at least 5 consecutive seconds under the following condition.
    VHCL SPEED SE CHART

    VHCL SPEED SE More than 30 km/h (19 MPH)
    Shift lever Suitable position

    If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE  "

    Fig 1: Identifying CONSULT-II Display Screen Data Monitor
    G02361019Courtesy of NISSAN MOTOR CO., U.S.A.

    If 1st trip DTC is not detected, go to the following step.

  5. Drive the vehicle for at least 5 consecutive seconds under the following condition.
    VHCL SPEED SE CHART

    VHCL SPEED SE More than 30 km/h (19 MPH)
    Shift lever Suitable position
    Driving location Depress the brake pedal for more than five seconds so as not to come off from the above-mentioned vehicle speed.
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE  ".
scientia non olet · About Mike's Workshop Manuals