Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1165 (Engine Control System - Qr25DE) >> DTC P0442: EVAP Control System >> Diagnostic Trouble Code (DTC) Confirmation Procedure >> Testing Condition: >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2004 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
  4. Check the following conditions are met.

    COOLAN TEMP/S: 0 - 70°C (32 - 158°F) 

    INT/A TEMP SE: 0 - 30°C (32 - 86°F) 

  5. Select "EVAP SML LEAK P0442/P1442" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-II.

    Follow the instruction displayed.

    Fig 1: DTC Confirmation Test (With Consult-II)
    G00777940Courtesy of NISSAN MOTOR CO., U.S.A.
    NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT-II screen, GO TO "BASIC INSPECTION ".
  6. Make sure that "OK" is displayed.
  7. If "NG" is displayed, refer to "DIAGNOSTIC PROCEDURE ".
    NOTE: Make sure that EVAP hoses are connected to the EVAP canister purge volume control solenoid valve properly.
    Fig 2: Ensuring OK Is Displayed On Consult-II
    G00777941Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals