3. Check Harness Between Brake Fluid Level Sensor And VDC/TCS/Abs Control Unit

WARNING: This page is about a different car, the 2004 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch OFF and disconnect brake fluid level sensor connector and VDC/TCS/ABS control unit connectors.
Check the continuity between brake fluid level sensor harness connector E44 and VDC/TCS/ABS control unit connector E118.

Fig 1: VDC/TCS/ABS Control Unit & Brake Fluid Level Sensor Circuit Connector Terminals
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: VDC/TCS/ABS Control Unit & Brake Fluid Level Sensor Circuit Harness Inspection Table
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Connect connectors and conduct a VDC/TCS/ABS control unit self-diagnosis.

NG: If the open or short in harness, repair or replace harness.