Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1976 (Engine Control System - VK45DE) >> DTC P1572: ASD Brake Switch >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2005 Infiniti FX45. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine (VDC switch OFF).
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Press MAIN switch and make sure that CRUISE lamp lights up.
  4. Drive the vehicle for at least 5 consecutive seconds under the following conditions.
    VHCL SPEED SE AND MORE THAN 30 KM/H (19 MPH)

    VHCL SPEED SE More than 30 km/h (19 MPH)
    Selector lever Suitable position

    If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE  ".

    If 1st trip DTC is not detected, go to the following step.

    Fig 1: Displaying Data Monitor
    G02358753Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Drive the vehicle for at least 5 consecutive seconds under the following conditions.
    VHCL SPEED SEE AND MORE THAN 30 KM/H (19 MPH)

    VHCL SPEED SEE More than 30 km/h (19 MPH)
    Selector lever Suitable position
    Driving location Depress the brake pedal for more than five seconds so as not to come off form the above-mentioned vehicle speed.
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE  ".
scientia non olet · About Mike's Workshop Manuals