Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1112 (Brake Control System) >> Abs >> Trouble Diagnosis >> Basic Inspection >> Basic Inspection 1 Brake Fluid Level, Leaks, And Brake Pads

Basic Inspection 1 Brake Fluid Level, Leaks, And Brake Pads

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check fluid level in the brake reservoir tank. If fluid level is low, refill brake fluid.
  2. Check brake piping and around ABS actuator and electric unit (control unit) for leaks. If leakage or seepage is found, check the following items.
    • If ABS actuator and electric unit (control unit) connection is loose, tighten piping to the specified torque and re-conduct the leak inspection to make sure there are no leakage.
    • If there is damage to the connection flare nut or ABS actuator and electric unit (control unit) screw, replace the damaged part and re-conduct the leak inspection to make sure there are no leakage.
    • If there is leakage or seepage at any location other than ABS actuator and electric unit (control unit) connection, wipe away leakage or seepage with clean cloth. Then inspect again and confirm than there is on leakage.
    • If there is leakage from ABS actuator and electric unit (control unit), wipe away leakage or seepage with clean cloth. Then inspect again. If there is leakage or seepage, replace ABS actuator and electric unit (control unit).
      CAUTION: ABS actuator and electric unit (control unit) body cannot be disassembled.
  3. Check the brake disc rotor and pads. Refer to DISC .
scientia non olet · About Mike's Workshop Manuals