Limit Switch Circuit Check (Passenger Side)

WARNING: This page is about a different car, the 2004 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

CHECK POWER WINDOW SUB-SWITCH (PASSENGER SIDE) LIMIT SIGNAL

Turn ignition switch ON.

Check voltage between power window motor (front passenger side) connector and ground.

POWER WINDOW MOTOR (FRONT PASSENGER SIDE) CONNECTOR AND GROUND VOLTAGE SPECIFICATIONS

Connector	Terminals (Wire color)		Condition of window	Voltage [V] (Approx.)
Connector	(+)	(-)	Condition of window	Voltage [V] (Approx.)
D38	5 (G/W)	Ground	Passenger side door window is between fully-open and just before fully-closed position (ON)	0
D38	5 (G/W)	Ground	Passenger side door window is between just before fully closed position and fully closed position (OFF)	5

Fig 1: Checking Voltage Between Power Window Motor (Front Passenger Side) Connector & Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Limit sw circuit is OK.
NG: GO TO 2.

CHECK LIMIT SWITCH GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect power window motor (front passenger side) connector.
3. Check continuity between power window motor (front passenger side) connector D38 terminal 6 and ground.
  6 (W/B) - Ground: Continuity should exist.
  
  Fig 2: Checking Continuity Between Power Window Motor (Front Passenger Side) Connector D38 Terminal 6 & Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
1. OK: GO TO 4 .
2. NG: GO TO 3.
CHECK HARNESS CONTINUITY
1. Disconnect power window sub-switch (front passenger side) connector.
2. Check continuity between power window motor (front passenger side) connector D38 terminal 6 and power window sub-switch (front passenger side) connector D36 terminal 20.
  6 (W/B) - 20 (W/B): Continuity should exist.
  
  Fig 3: Checking Harness Continuity
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
1. OK: Replace power window sub-switch (front passenger side).
2. NG: Repair or replace harness between power window subs-witch and power window motor (front passenger side).
CHECK POWER WINDOW SUB-SWITCH (FRONT PASSENGER SIDE) OUTPUT SIGNAL
1. Turn ignition switch ON.
2. Check voltage between power window sub-switch (front passenger side) connector D36 terminal 16 and ground.
  16 (G/W) - Ground: Approx. 5V
  
  Fig 4: Checking Voltage Between Power Window Sub-Switch (Front Passenger Side) Connector D36 Terminal 16 & Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
1. OK: GO TO 5.
2. NG: Replace power window sub-switch (front passenger side).
CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect power window sub-switch (front passenger side) connector.
3. Check continuity between power window sub-switch (front passenger side) connector D36 terminal 16 and power window motor (front passenger side) connector D38 terminal 5.
  16 (G/W) - 5 (G/W): Continuity should exist.
  
  Fig 5: Checking Continuity Between Power Window Sub-Switch (Front Passenger Side) Connector D36 Terminal 16 & Power Window Motor Connector D38 Terminal 5
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
1. OK: Replace power window motor (front passenger side).
2. NG: Repair or replace harness.