Procedure For DTC P0102

WARNING: This page is about a different car, the 2004 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.

With CONSULT-II

Turn ignition switch ON.
Select "DATA MONITOR" mode with CONSULT-II.
Start engine and wait at least 5 seconds at most.
If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
If DTC is not detected, go to next step.
Start engine and let it idle for at least 6 seconds.
If DTC is detected, go to DIAGNOSTIC PROCEDURE ".

Fig 1: Reading "ENG SPEED" In "Data Monitor" Mode
Courtesy of NISSAN MOTOR CO., U.S.A.

With GST

Follow the procedure "With CONSULT-II".