Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2003 >> Frontier Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 401 (Engine Control System - KA24DE) >> DTC P0453: EVAP Control System Pressure Sensor >> DTC Confirmation Procedure >> Testing Condition: >> With GST

With GST

WARNING: This page is about a different car, the 2004 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine and warm it up to normal operating temperature.
  2. Check that voltage between ECM terminal 60 (Fuel tank temperature sensor signal) and ground is less than 4.2V.
  3. Turn ignition switch OFF and wait at least 5 seconds.
  4. Start engine and wait at least 20 seconds.
  5. Select "MODE 7" with GST.
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
Fig 1: Checking Voltage Between ECM Terminal
G00857231Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals