Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2003 >> Frontier Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 401 (Engine Control System - KA24DE) >> DTC P0452: EVAP Control System Pressure Sensor >> DTC Confirmation Procedure >> Testing Condition: >> With CONSULT-II

With CONSULT-II

WARNING: This page is about a different car, the 2004 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine and warm it up to normal operating temperature.
  2. Turn ignition switch OFF and wait at least 5 seconds.
  3. Turn ignition switch ON.
  4. Select "DATA MONITOR" mode with CONSULT-II.
    Fig 1: Scan Tool Display - Data Monitor
    G00857216Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Make sure that "FUEL T/TMP SE" is more than 0°C (32°F).
  6. Start engine and wait at least 20 seconds.
  7. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals