Testing Condition

WARNING: This page is about a different car, the 2004 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.

Perform "DTC WORK SUPPORT" when the fuel level is between 1/4 and 3/4 full, and vehicle is placed on flat level surface.
Always perform test at a temperature of 0 to 30°C (32 to 86°F).

Turn ignition switch ON.
Turn ignition switch OFF and wait at least 5 seconds.
Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.

Fig 1: Scan Tool Display - Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.
Check that the following conditions are met.

Fig 2: Temperature Chart
Courtesy of NISSAN MOTOR CO., U.S.A.
Select "EVAP SML LEAK P0442/P1442" of "EVAP SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-II. Follow the instruction displayed.

Fig 3: Scan Tool Display
Courtesy of NISSAN MOTOR CO., U.S.A.
NOTE:
- If the engine cannot be maintained within the range on CONSULT-II screen, go to , "Basic Inspection ".
Make sure that "OK" is displayed.
If "NG" is displayed, refer to , "DIAGNOSTIC PROCEDURE ".

Fig 4: Scan Tool Display

Courtesy of NISSAN MOTOR CO., U.S.A.