Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2003 >> Frontier Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 401 (Engine Control System - KA24DE) >> DTC P0441: EVAP Control System >> DTC Confirmation Procedure >> Testing Condition: >> With CONSULT-II

With CONSULT-II

WARNING: This page is about a different car, the 2004 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine and warm it up to normal operating temperature.
  2. Turn ignition switch OFF and wait at least 5 seconds.
  3. Start engine and let it idle for at least 60 seconds.
  4. Select "PURG FLOW P0441" of "EVAP SYSTEM" in "DTC CONFIRMATION" mode with CONSULT-II.
  5. Touch "START".

    If "COMPLETED" is displayed, go to step  7.

  6. When the following conditions are met, "TESTING" will be displayed on the CONSULT-II screen. Maintain the conditions continuously until "TESTING" changes to "COMPLETED". (It will take at least 30 seconds.)
    Fig 1: Selector Lever Chart
    G00857137Courtesy of NISSAN MOTOR CO., U.S.A.

    If "TESTING" is not changed for a long time, retry from step 2. 

    Fig 2: Scan Tool Display
    G00857138Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Make sure that "OK" is displayed after touching "SELF-DIAG RESULTS". If "NG" is displayed, refer to DIAGNOSTIC PROCEDURE .
scientia non olet · About Mike's Workshop Manuals