Section 818 (Continuously Variable Transmission (CVT)): Precautions: Precautions

WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If any malfunctions occur in the RE0F09A model transmission, replace the entire transmission assembly.

Before connecting or disconnecting the TCM harness connector, turn ignition switch OFF and disconnect negative battery cable. Because battery voltage is applied to TCM even if ignition switch is turned OFF.
When connecting or disconnecting pin connectors into or from TCM, take care not to damage pin terminals (bend or break).
When connecting pin connectors make sure that there are not any bends or breaks on TCM pin terminal.
Before replacing TCM, perform TCM input/output signal inspection and make sure whether TCM functions properly or not. TCM INSPECTION TABLE .
After performing each TROUBLE DIAGNOSIS, perform DTC (Diagnostic Trouble Code) CONFIRMATION PROCEDURE.
If the repair is completed the DTC should not be displayed in the DTC CONFIRMATION PROCEDURE.
Always use the specified brand of CVT fluid.
Use paper rags, not cloth rags, during work.
After replacing the CVT fluid, dispose of the waste oil using the methods prescribed by law, ordinance, etc.