Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2002 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 407 (Engine Control System - Introduction) >> Power Supply Circuit For ECM >> Diagnostic Procedure >> 7) Check ECM Power Supply Circuit-II

7) Check ECM Power Supply Circuit-II

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Reconnect ECM harness connector.
  2. Turn ignition switch ON.
  3. Check voltage between IPDM E/R terminal 17 and ground with CONSULT-II or tester.
    1. Voltage: Battery voltage 

OK or NG 

  1. OK: Go to , "IGNITION SIGNAL ".
  2. NG: GO TO 8.
Fig 1: Check ECM Power Supply Circuit-II
G00875839Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals