Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2002 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2322 (Engine Control System - DTCS P0448 To P0850) >> DTC P0462, P0463 Fuel Level Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is more than 11V at ignition switch ON  .

  1. Turn ignition switch ON.
  2. Wait at least 5 seconds.
  3. Check 1st trip DTC.
  4. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "

WITH GST 

Follow the procedure "WITH CONSULT-III" above.

scientia non olet · About Mike's Workshop Manuals