Front Door Lock Actuator RH Check

1. Turn ignition switch OFF.
2. Disconnect BCM and front door lock actuator RH.
3. Check continuity between BCM connector M20 terminals 65, 66 and front door lock actuator RH connector D114 terminals 2, 3.
   TERMINALS CONTINUITY CHART
   
   

   Connector	Terminals	Connector	Terminals	Continuity
   M20	65	D114	3	Yes
   	65		2	Yes

4. Check continuity between BCM connector M20 terminals 65, 66 and body ground.
   TERMINALS CONTINUITY CHART
   
   

   Connector	Terminals		Continuity
   M20	65	Ground	No
   	66		No

   Fig 1: Identifying Connector M20 Terminals 65, 66 And Front Door Lock Actuator RH D114 Terminals 2, 3

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: GO TO 2.

NG: Repair or replace harness.

1. Reconnect BCM.
2. Check voltage between BCM connector M20 terminals 65, 66 and ground.
   TERMINALS VOLTAGE CHART
   
   

   Connector	Terminals		Condition	Voltage (V) (Approx.)
   	(+)	(-)
   M20	65	Ground	Door lock/unlock switch is turned to LOCK	0 → Battery voltage for 300 ms
   	66		Door lock/unlock switch is turned to UNLOCK	0 → Battery voltage for 300 ms

   Fig 2: Checking Voltage Between BCM Connector M20 Terminals 65, 66 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Replace front door lock actuator RH. Refer to "REMOVAL AND INSTALLATION ".

NG: Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".