Inspection Procedure

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

SELF-DIAGNOSIS RESULT CHECK
Check self-diagnosis results.
SELF-DIAGNOSIS RESULTS TABLE

Self-diagnosis results

BATTERY VOLTAGE

Is the above displayed in the self-diagnosis display items?
- YES: GO TO 2.
- NO: Inspection End.
CONNECTOR INSPECTION
1. Disconnect the ABS actuator and electric unit (control unit) connector E125.
2. Check the terminals for deformation, disconnection, looseness or damage.
OK or NG
- OK: GO TO 3.
- NG: Repair or replace as necessary.
ABS/TCS CONTROL UNIT POWER AND GROUND CIRCUIT INSPECTION
Measure the voltage and continuity between the ABS actuator and electric unit (control unit) connector E125 and ground.

Fig 1: Voltage & Continuity Chart
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG
- OK: Check the battery for loose terminals, low voltage, etc. Repair as necessary.
- NG: Repair the circuit.