Removal and Installation: Installation
WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal.
- Refer to "BRAKE PIPING AND HOSE " when connecting the brake tubes.
CAUTION:
To install, use a flare nut wrench (commercial service tool).
- Always tighten the brake tubes to the specified torque when installing.
- Never reuse drained brake fluid.
- After installation of the ABS actuator and electric unit (control unit), refill the brake system with new brake fluid. Then bleed the air from the system. Refer to "BLEEDING BRAKE SYSTEM ".