Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2000 >> Altima GLE >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Diagnostic Tests >> DTC P0171 Or P0172: Fuel Injection System Function >> Procedure

DTC P0171 Or P0172: Fuel Injection System Function: Procedure

  1. Start engine and let it idle. Check for leaks in exhaust system before 3-way catalyst. Check for leaks in intake system after MAF sensor. Repair or replace faulty components as required and retest system. If no leaks are detected, go to next step.
  2. Turn ignition off. Disconnect front HO2S harness connector and ECM harness connector. See Figure. Check continuity of White wire between ECM harness connector terminal No. 46 and front HO2S harness connector. See Figure. Also check circuit for short to ground and short to voltage. Repair as necessary and retest system. If circuit is okay, go to next step.
  3. Reconnect all harness connectors. Check fuel pressure. See BASIC DIAGNOSTIC PROCEDURES article. If fuel pressure is not okay, check fuel pump, fuel pressure regulator and fuel lines. Repair as necessary. If fuel pressure is okay, go to next step.
  4. Start engine and let it idle. Select MODE 1 with scan tool and check mass airflow. Mass airflow should be about 3.24 g/sec. If scan tool is not available, measure voltage between ground and ECM terminal No. 47 by backprobing. See Figure. Voltage should be 1.2-1.5 volts. Increase engine speed to 2500 RPM. Mass airflow should be about 12.2 g/sec. Voltage should be 1.9-2.3 volts. If operation is as specified, go to next step. If operation is not as specified, repair MAF sensor or circuit. See DTC P0100: MASS AIRFLOW (MAF) SENSOR .
  5. With engine idling, listen to each injector for clicking noise. If any injector does not click, repair circuit or replace injector. See SYSTEM & COMPONENT TESTING article. If all injectors click, turn ignition off and allow engine to cool. Go to next step.
  6. Ensure no fire hazards exist and remove injector assembly with fuel lines and harness connectors connected. Place a suitable cup under each injector to collect fuel. Disconnect all ignition coil harness connectors. Turn ignition on. Verify fuel is not dripping from injectors. Replace injectors which are leaking. Crank engine for 3 seconds and ensure each injector sprays fuel. If injectors are okay, go to next step.
  7. No problem is indicated at this time. Problem may be intermittent. See TESTING PROCEDURE under SELF-DIAGNOSTIC SYSTEM in SELF-DIAGNOSTICS - INTRODUCTION article.