Final Check For All Circuit Tests

WARNING: This page is about a different car, the 1995 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

Unless otherwise instructed in code inspection, perform following final check after each repair is completed:

Erase diagnostic test Mode II or Mode III (self-diagnostic results) memory. See CLEARING CODES under SELF-DIAGNOSTIC SYSTEM.
Ensure Code 55 (no malfunction) is displayed in self-diagnostic mode.
Perform a test drive.
Perform diagnostic test Mode II or Mode III (self-diagnostic results) again. If results are okay, inspection is complete. If results are not okay, ensure ECM pin terminals and ECM harness connector are not damaged.