Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 1996 >> Maxima GLE, RE4F04A >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests 3.0L >> Engine Sensors & Switches >> Neutral Position Switch System Test

Neutral Position Switch System Test

  1. Turn ignition off. Disconnect neutral position switch 4-pin harness connector. Connector is located on top of transaxle. Check continuity between ground and Black wire of neutral position switch 4-pin harness connector. Continuity should exist. If continuity exists, go to next step. If continuity does not exist, repair open Black wire or connectors.
  2. Disconnect ECM harness connector. Check continuity between ECM harness connector terminal No. 22 (Green/White wire) and neutral position switch 4-pin harness connector Green/White wire. Continuity should exist. If continuity exists, go to next step. If continuity does not exist, repair open harness or connectors.
  3. Check neutral position switch. See NEUTRAL POSITION  SWITCH. Replace switch if necessary. If switch is okay, disconnect and inspect harness and connector for pushed-out, bent, damaged or corroded terminals. Repair harness or connector as necessary.
scientia non olet · About Mike's Workshop Manuals