Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 1996 >> 200SX SE-R, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.0L >> Circuit Tests >> DTC P1605 - Automatic Transmission (A/T) Control >> Check Input Signal Circuit

Check Input Signal Circuit

Turn ignition switch to OFF position. Disconnect ECM and A/T control unit harness connectors. Using an ohmmeter, check continuity between ECM harness connector terminal No. 7 and A/T control unit harness connector terminal No. 13 (Purple wire). If no continuity exists, repair open in Purple wire. If continuity exists, disconnect and reconnect harness connectors in circuit and perform FINAL CHECK .

scientia non olet · About Mike's Workshop Manuals