Temperature Control Cable & Heater Valve Control Rod

NOTE: Before adjusting heater valve control rod, disconnect temperature control cable from blend-air door. After adjusting control rod, install temperature control cable and adjust it as necessary.

1. Place temperature lever to maximum hot setting. Disconnect temperature control cable from blend-air door lever.
2. Pull heater valve control rod in direction of arrow to obtain .08"(2.0 mm) clearance between ends of rod and link lever. See Fig 1 . Connect rod to door lever. Check operation of air mix door.
3. Push temperature control cable and air mix door lever in direction of arrow. See Fig 2 . Install retaining clip.

Fig 1: Adjusting Heater Valve Control Rod (Typical)

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Adjusting Temperature Control Cable (NX & Sentra Are Similar)

Courtesy of NISSAN MOTOR CO., U.S.A.