DTC 35, EGR Temperature Sensor
- Check Input Signal
- Start engine and warm to operating temperature. Measure voltage between ECM terminal No. 39 and ground. See Figure
and Fig 2
. Voltage should be less than 4.5 volts. If voltage is correct, go to next step. If voltage is not correct, go to step 3).
- Check Circuit Continuity
- Turn ignition off. Disconnect ECM and EGR temperature sensor wiring harness connector. See Figure
and Fig 1
. Check continuity between ECM connector terminal No. 39 and EGR temperature sensor connector terminal "a" (Orange/Black wire). See Figure
and Fig 3
.If continuity is present, go to next step. If continuity is not present, repair harness or connectors as necessary.
- Check Component
- Inspect EGR temperature sensor. See I - SYS/COMP TESTS article. Replace EGR temperature sensor if necessary, and perform FINAL CHECK
in this article. If EGR temperature sensor is okay, repair ECM pin terminals and/or wiring harness connector.
- Check Ground Circuit
- Turn ignition off. Disconnect ECM and EGR temperature sensor wiring harness connector. See Figure
and Fig 1
. Check continuity between ECM connector terminal No. 30 and EGR temperature sensor connector terminal "b" (Black wire). See Figure
and Fig 4
.If continuity is present, repair ECM pin terminals and/or wiring harness connector, and perform FINAL CHECK
in this article. If continuity is not present, repair harness or connectors as necessary.
Courtesy of NISSAN MOTOR CO., U.S.A.
Courtesy of NISSAN MOTOR CO., U.S.A.
Courtesy of NISSAN MOTOR CO., U.S.A.
Courtesy of NISSAN MOTOR CO., U.S.A.