DTC Confirmation Procedure

If DTC P0507 is displayed with other DTC, first perform the trouble diagnosis for the other DTC.

Is applicable DTC detected? 

YES >>

Perform diagnosis of applicable. Refer to DTC INDEX .

NO >>

GO TO  2.

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

If the target idle speed is out of the specified value, refer to WORK PROCEDURE , before conducting DTC Confirmation Procedure.

TESTING CONDITION:

• Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.
• Always perform the test at a temperature above -10°C (14°F).

>>

GO TO  3.

1. Start engine and warm it up to normal operating temperature.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Start engine and run it for at least 1 minute at idle speed.
4. Check 1st trip DTC.

Is 1st trip DTC detected? 

YES >>

Proceed to DTC DIAGNOSIS PROCEDURE .

NO-1 >>

To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

NO-2 >>

Confirmation after repair: INSPECTION END