DTC Confirmation Procedure: Notes

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 10 V at idle.

>>

GO TO  2.

1. Turn ignition switch ON.
2. Turn ignition switch OFF, wait at least 10 seconds.
3. Turn ignition switch ON.
4. Repeat steps  2 and  3 for 32 times.
5. Check 1st trip DTC.

Is 1st trip DTC detected? 

YES >>

Proceed to DTC DIAGNOSIS PROCEDURE .

NO-1 >>

To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

NO-2 >>

Confirmation after repair: INSPECTION END