DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is between 12 - 15 V at idle.

>>

GO TO  2.

1. Start engine and let it idle for at least 20 seconds.
2. Check 1st trip DTC.

Is 1st trip DTC detected? 

YES >>

Refer to DTC DIAGNOSIS PROCEDURE .

NO-1 >>

To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

NO-2 >>

Confirmation after repair: INSPECTION END