Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2024 >> Outlander ES, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (DTC/Circuit Diagnosis) (3 Of 4) >> DTC/Circuit Diagnosis >> DTC P06E6: Internal Control Module >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK ECM POWER SUPPLY AND GROUND CIRCUIT 

    Perform trouble diagnosis for ECM power supply and ground circuit. Refer to DTC DIAGNOSIS PROCEDURE .

    Is the inspection result normal? 

    YES >>

    GO TO  2.

    NO >>

    Repair or replace error-detected parts.

  2. CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR POWER SUPPLY CIRCUIT-1 
    1. Turn ignition switch OFF.
    2. Disconnect EVAP control system pressure sensor harness connector.
    3. Turn ignition switch ON.
    4. Check the voltage between EVAP control system pressure sensor harness connector and ground.
    + - Voltage (Approx.)
    EVAP control system pressure sensor
    Connector Terminal
    C51 3 Ground 5V

    Is the inspection result normal? 

    YES >>

    INSPECTION END

    NO >>

    GO TO  3.

  3. CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR SUPPLY CIRCUIT-2 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check the continuity between EVAP control system pressure sensor harness connector and ECM harness connector.
    + + Continuity
    EVAP control system pressure sensor ECM
    Connector Terminal Connector Terminal
    C51 3 E16 133 Existed

    Is the inspection result normal? 

    YES >>

    GO TO  4.

    NO >>

    Repair open circuit.

  4. CHECK SENSOR POWER SUPPLY 3 CIRCUIT 
    1. Disconnect following sensors harness connector.
    2. Check harness for short to power and short to ground, between the following terminals.
    ECM Sensor
    Connector Terminal Name Connector Terminal
    E16 133 EVAP control system pressure sensor C51 3

    Is the inspection result normal? 

    YES >>

    GO TO  5.

    NO >>

    Repair short to ground or short to power in harness or connectors.

  5. CHECK INTERMITTENT INCIDENT 

    Check intermittent incident. Refer to INTERMITTENT INCIDENT .

    Is the inspection result normal? 

    YES >>

    GO TO  6.

    NO >>

    Repair or replace error-detected parts.

  6. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Turn ignition switch ON.
    2. Erase DTC.
    3. Perform DTC confirmation procedure. Refer to DTC DESCRIPTION .

    Is the 1st trip DTC P06E6 displayed again? 

    YES >>

    Replace ECM. Refer to ECM: REMOVAL & INSTALLATION .

    NO >>

    INSPECTION END

scientia non olet · About Mike's Workshop Manuals