Work Procedure

Always perform the additional service after replacing the ADAS control unit 2.

1. ADAS CONTROL UNIT 2 CONFIGURATION 

   Perform the ADAS control unit 2 configuration. Refer to WORK PROCEDURE 

   >>

   GO TO 2 

2. WRITING MAC KEY 

   Perform MAC key writing. Refer to WORK PROCEDURE .

   With MI-PILOT Assist >>

   GO TO 3 

   Without MI-PILOT Assist >>

   INSPECTION END

3. STEERING TORQUE CALIBRATION 

   Perform the steering torque calibration. Refer to WORK PROCEDURE (PREPARATION) .

   >>

   INSPECTION END