Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2022 >> Outlander SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Cruise Control System) >> System Description >> Operation >> Vehicle-To-Vehicle Distance Control Mode Function >> FULL TFT METER - Operation Guidance >> Switch Name And Function

Switch Name And Function

WARNING: This page is about a different car, the 2024 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
G16045612Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
No. Switch name Description
(1) MI-PILOT Assist MAIN switch MI-PILOT Assist MAIN switch to activate the system (Press for less than 1.5 seconds)
(2) CANCEL switch Pressing the switch cancels MI-PILOT Assist control
(3) RES+ switch Resumes set speed or increases speed incrementally
  • Push and hold the switch to increase the set speed by 5 km/h (5 MPH)
  • Push then quickly release the switch to increase the set speed by 1 km/h (1 MPH)
(4) SET- switch Sets desired cruise speed or reduces speed incrementally
  • Push and hold the switch to decrease the set speed by 5 km/h (5 MPH)
  • Push then quickly release the switch to decrease the set speed by 1 km/h (1 MPH)
    NOTE: The minimum set speed is 30 km/h (20 MPH)
(5) DISTANCE switch Changes the following distance from: Long, Middle, Short
scientia non olet · About Mike's Workshop Manuals