Work Procedure

Perform the following procedures after replacing the multi-around monitor control unit.

1. REPLACE MULTI-AROUND MONITOR CONTROL UNIT 

   Replace multi-around monitor control unit. Refer to REMOVAL AND INSTALLATION

   >>

   GO TO 2 

2. WRITING MAC KEY 

   Perform MAC key writing. Refer to DESCRIPTION .

   >>

   GO TO 3 

3. PERFORM CONFIGURATION 
   CAUTION: When before writing the multi-around monitor control unit configuration, always writing the MAC key.

   Perform configuration. Refer to DESCRIPTION .

   >>

   GO TO 4 

4. WRITING OF CALIBRATION DATA 

   Write the calibration data stored in the camera using M.U.T.-III SE. Refer to Work Procedure DIAGNOSIS PROCEDURE .

   >>

   GO TO 5 

5. PERFORM SELF-DIAGNOSIS 
   1. Perform the self-diagnosis of multi-around monitor control unit with M.U.T.-III SE (Multi Around Monitor).
   2. Check if any DTC is detected.

   Is any DTC detected? 

   YES >>

   Perform the trouble diagnosis for the detected DTC. Refer to DTC INDEX .

   NO >>

   GO TO 6 

6. OPERATION CHECK 

   Confirm that the operation of the multi-around monitor and the camera image (reference line, expected route) are normal.

   >>

   WORK END