MITSUBISHI Remote Control
- MITSUBISHI Remote Control
- Special Tools
- Diagnosis
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC B1E00: EV Remote Security No Reg
- DTC U0141: ETACS CAN timeout
- DTC U0155: Meter CAN timeout
- DTC U0164: A/C CAN timeout
- DTC U0168: WCM/F.A.S.T. CAN timeout
- DTC U0230: Power Gate CAN timeout
- DTC U0245: NAVI/DISP.AUDIO CAN timeout
- DTC U1000: OSS CAN timeout
- DTC U1190: No receive fault detect signal
- DTC U1417: Implausible coding data
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: A wireless LAN device cannot communicate with the vehicle (EV remote-ECU) only (The device can communicate with another device)
- Inspection Procedure 2: Under some circumstances, a wireless LAN device cannot communicate with the vehicle (EV remote-ECU) only (The device can communicate with another device)
- Inspection Procedure 3: The timed charging is impossible (wireless LAN communication is normal)
- Inspection Procedure 4: The remote climate control is impossible (wireless LAN communication is normal)
- Inspection Procedure 5: The timed charging does not work correctly (timer setting itself is possible)
- Inspection Procedure 6: The remote climate control does not work correctly (timer setting itself is possible)
- Inspection Procedure 7: The 12V starter battery becomes flat frequently
- Inspection Procedure 8: Customization settings cannot be changed
- Inspection Procedure 9: Vehicle information is not displayed normally (actual vehicle status is different from the status displayed)
- Inspection Procedure 10: "Parking location check" is impossible (headlights/taillights)
- Inspection Procedure 11: Cannot communicate with EV remote-ECU using the M.U.T.-IIISE
- Inspection Procedure 12: The external power supply function is not started (execution button operation is possible)
- Data List Reference Table
- Actuator Test Table
- Special Function
- Check At EV Remote-Ecu Terminal
- Removal And Installation