Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2019 >> Outlander ES, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Front Axle) >> Front Axle Hub Assembly >> Disassembly And Assembly >> Assembly Service Points >> >>C<< Hub Rotation Starting Torque Check

>>C<< Hub Rotation Starting Torque Check

WARNING: This page is about a different car, the 2018 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set special tools MB991000, MB991017 and MB991099 as shown in the illustration, tighten the nut to the specified torque, and press-fit the hub into the knuckle.

    Tightening torque: 250 ± 25 N.m (184 ± 18 ft-lb) 

  2. Rotate the hub to make the bearing well-greased.
    G12120161Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Use Special tool MB990326 to measure the hub rotation starting torque.

    Limit: 1.5 N.m (13 in-lb) 

  4. Hub rotation starting torque should be within the limit value, and there should be no roughness and gritty feeling in rotation.
G05432086Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals