Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2019 >> Outlander ES, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Electronic Control Modules (Service Information)) >> Module, Comfort Seat And Wheel (CSWM) >> Installation

Module, Comfort Seat And Wheel (CSWM): Installation

WARNING: This page is about a different car, the 2020 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.

  1. Install the Comfort Seat and Wheel Module (CSWM) to the seat frame.
    GC0177038Courtesy of CHRYSLER GROUP, LLC
  2. Connect the wire harness connectors (1) to the module (2).
  3. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
scientia non olet · About Mike's Workshop Manuals