Special Tools
WARNING: This page is about a different car, the 2017 Mitsubishi Mirage. However, it is still accessible from the selected car via links, so may be relevant.
| Tool | Tool number and name | Supersession | Application |
|---|---|---|---|
| MB991618 Hub bolt remover |
General service tool | Removal of the hub bolt | |
| MB990767 Front hub and flange yoke holder |
MB990767-01 | Fixing of the hub | |
| MB992700 Lock nut chisel |
General service tool | Raising up the swaged part driveshaft nut | |
| MB991897 or MB992011 Ball joint remover |
MB991113-01, MB990635-01 or General service tool | Knuckle and tie-rod end ball joint disconnection
NOTE:
Steering linkage puller (MB990635 or MB991113) is also used to disconnect knuckle and tie-rod end ball joint.
|
|
| MB990241 Axle shaft puller
|
MB990241-01 or General service tool | Removal of the driveshaft | |
| MB991056 or MB991355 Knuckle arm bridge |
MB991056-01 |
|
|
| MB992250 Knuckle arm bridge attachment |
- | ||
|
MB990998-01 |
|
|
| MB992867 Front hub removal and installer spacer |
- | Removal of hub Measurement of Wheel bearing rotation starting torque |
|
| MD998801 Remover |
- | Removal of the wheel bearing inner race (outside) | |
| MB992254 Base |
- | Removal of wheel bearing outer race | |
| MD999547 Oil seal installer |
- | Removal of wheel bearing outer race | |
| MB990800 Ball joint B remover and installer |
- | Hub press-fitting | |
| MB990799 Ball joint A remover and installer |
- | Press-fitting of wheel bearing | |
| MD998812 Installer cap |
- | Press-fitting of wheel bearing | |
| MD998813 Installer |
- | ||
| MD998815 Installer adapter |
- | ||
| MB991000 Spacer |
- |
|
|
| MB991199 Oil seal installer |
- | Press-fitting of hub | |
| MB990685 Torque wrench |
General service tool | Measurement of wheel bearing starting torque | |
| MB990326 Preload socket |
General service tool | ||
| MB991561 Boot band crimping tool |
MB991561 | EBJ boot (resin boot) band installation |