Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2015 >> Lancer Evolution Final Edition >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 43 (Basic Brake System - Lancer) >> Brake Pedal >> Inspection >> Stoplight Switch Check >> < Vehicles Without Cruise Control System >

< Vehicles Without Cruise Control System >

WARNING: This page is about a different variant/trim than selected.
CAUTION: Do not apply grease or lubricant to the switch and the switch installation section to avoid malfunction of the switch. In addition, do not use gloves which have grease on them.

Check for continuity between the terminals of the switch.

Check condition Terminal connector of tester Normal condition
At free position 1 - 2 Continuity exists (2 Ω or less)
Press the plunger from the edge of the outer case by the dimension shown in the illustration. 1 - 2 No continuity
Fig 1: Checking Stoplight Switch
G09627012Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals