Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2012 >> i-MiEV ES >> Repair and Diagnosis >> Brakes >> Traction Control >> Active Stability Control System (ASC) - With Diagnostics >> On-Vehicle Service >> Steering Wheel Sensor Calibration

Steering Wheel Sensor Calibration

CAUTION: After the next operation has been completed, carry out the following two operations:
  • Alignment adjustment < Front >
  • Steering wheel sensor (column switch assembly) replacement, removal, installation
  1. Update the neutral position stored in the steering wheel sensor.
  2. Reset the calibrated value of the steering angle stored in ASC-ECU.
CAUTION:
  • Before performing the calibration, check if the steering wheel sensor-related DTC is set in ASC-ECU.
  • When the DTC other than C1394 is set, carry out the inspection according to each troubleshooting procedure.
  1. Park the vehicle on a level surface with tires and steering wheel positioned in a straight ahead direction.
  2. Turn the electric motor switch to the "ON" position.
  3. Turn the electric motor switch to the "LOCK" (OFF) position.
    CAUTION: Before connecting or disconnecting scan tool, always turn the electric motor switch to the LOCK (OFF) position.
  4. Check that the electric motor switch is in the "LOCK" (OFF) position, and then set scan tool.
  5. Turn the electric motor switch to the "ON" position.
  6. On the Menu, select "System selection."
  7. In "System table" of "System selection," select "Steering angle sensor," and then press the "OK" button.
  8. In "Steering angle sensor," select "Special function."
  9. In "Special function," select "Learn neutral position of steering angle sensor."
    NOTE: When the neutral position of steering angle sensor has been learned, "Neutral position learned already: in order to relearn the neutral position, press the "OK" button to initialize the steering angle sensor neutral position." is displayed. If it is okay, press the "OK" button.
  10. In "Learn neutral position of steering angle sensor," "Initialize neutral position of steering angle sensor" is selected, thus press the "OK" button.
    NOTE: When the neutral position of steering angle sensor has been learned, "Initialize neutral position of steering angle sensor: Do you want to execute? Note: The DTC will be erased." is displayed. Then, press the "OK" button.
  11. "Initialize neutral position of steering angle sensor: Completed" is displayed. Then, press the "OK" button.
  12. Press the "OK" button.
  13. "Learn neutral position of steering angle sensor: Do you want to execute? Note: Execute after the tires and steering wheel are aligned in a straight ahead direction." is displayed. Then, press the "OK" button.
  14. "Learn neutral position of steering angle sensor: Completed" is displayed. Then, press the "OK" button.
  15. After turning the electric motor switch to "LOCK" (OFF) position, turn it to the "ON" position again.
  16. On the Menu, select "System selection."
  17. On the "System selection," select "ABS/ASC/ASTC" in the "System table," and then click the "OK" button.
  18. In the "ABS/ASC/ASTC" field, select "Special function".
  19. In the "Special function," select "Learn sensor neutral position."
  20. In "Learn sensor neutral position," select "Learn neutral position of steering angle sensor," and then press the "OK" button.
  21. "Learn neutral position of steering angle sensor: Are you sure to execute the selected item? Note: Check the execution conditions." is displayed. Then, press the "OK" button.
  22. "Execute command: Executed" is displayed. Then, press the "OK" button.
  23. The neutral point is learned.
  24. Turn the electric motor switch to the "LOCK" (OFF) position, and remove scan tool from the vehicle.
scientia non olet · About Mike's Workshop Manuals