Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2012 >> Lancer Evolution MR >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (General - Lancer) >> Maintenance Service - 2.0L Engine Non-Turbo, 2.4L Engine >> Transfer Oil (Check Oil Level And Condition/Change) >> Notes

Transfer Oil (Check Oil Level And Condition/Change): Notes

WARNING: This page is about a different variant/trim than selected.
  1. Remove the filler plug and gasket.
  2. Check that the oil level is just below the lower edge of the filler plug hole.
  3. Check that the oil is not excessively foul and has moderate viscosity.
  4. Install the filler plug and new gasket, then tighten them to the specified torque.

    Tightening torque: 32 - 2 N m (24 - 1 ft-lb) 

    Fig 1: Identifying Filler Plug And Drain Plug
    G05431351Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Identifying Filler Plug Hole, Filler Plug, And Gasket
    G06480808Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals