Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mitsubishi >> 2012 >> Lancer Evolution MR >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Basic Brake System - Lancer) >> Brake Pedal >> Brake Pedal Distortion Check

Brake Pedal Distortion Check

WARNING: This page is about a different variant/trim than selected.
  1. Place the brake pedal assembly on a level surface as shown in the illustration, and set the distance from the center of the pin assembly mounting hole to the level surface to 97 mm (3. 82 inches). Make sure that the dimension A in the illustration (distance from the pedal pad center part to the level surface) is within the standard value.

    Standard value (A): 

    237 - 245 mm (9.3 - 9.6 inches) < M/T > 

    240 - 248 mm (9.4 - 9.8 inches) < CVT, TC-SST > 

  2. When dimension A is not within the standard value, replace the brake pedal assembly.
    Fig 1: Identifying Distance Between Pedal Pad Center Part And Level Surface
    G05904676Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About Mike's Workshop Manuals