Trouble Symptom Chart For Input Signal

WARNING: This page is about a different variant/trim than selected.

TROUBLE SYMPTOM CHART

Trouble symptom	Inspection Procedure
Malfunction of the ignition switch (ACC) input/output signal	Refer to INSPECTION PROCEDURE 1: MALFUNCTION OF THE IGNITION SWITCH (ACC) INPUT/OUTPUT SIGNAL
Malfunction of the ignition switch (IG1) input/output signal	Refer to INSPECTION PROCEDURE 2: MALFUNCTION OF THE IGNITION SWITCH (IG1) INPUT/OUTPUT SIGNAL
ETACS-ECU does not receive any signal from the key reminder switch.	Refer to INSPECTION PROCEDURE 3: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE KEY REMINDER SWITCH.
ETACS-ECU does not receive any signal from the front door lock actuator.	Refer to INSPECTION PROCEDURE 4: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE FRONT DOOR LOCK ACTUATOR.
ETACS-ECU does not receive any signal from the front door switch (LH).	Refer to INSPECTION PROCEDURE 5: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE FRONT DOOR SWITCH (LH).
ETACS-ECU does not receive any signal from the front door switch (RH).	Refer to INSPECTION PROCEDURE 6: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE FRONT DOOR SWITCH (RH).
ETACS-ECU does not receive any signal from the rear door switch (LH).	Refer to INSPECTION PROCEDURE 7: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE REAR DOOR SWITCH (LH).
ETACS-ECU does not receive any signal from the rear door switch (RH).	Refer to INSPECTION PROCEDURE 8: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE REAR DOOR SWITCH (RH).
ETACS-ECU does not receive any signal from the trunk lid latch.	Refer to INSPECTION PROCEDURE 9: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE TRUNK LID LATCH.
ETACS-ECU does not receive any signal from the hazard warning light switch.	Refer to INSPECTION PROCEDURE 10: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE HAZARD WARNING LIGHT SWITCH.
ETACS-ECU does not receive any signal from the column switch signal.	Refer to INSPECTION PROCEDURE 11: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE COLUMN SWITCH SIGNAL.
ETACS-ECU does not receive any signal from the hood switch.	Refer to INSPECTION PROCEDURE 12: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE HOOD SWITCH.